Jm GRAIN CARTS Leaner Setup Manual do Utilizador

LEANER SETUP MANUAL(Rev. 06/09/12)J. & M. Mfg. Co., Inc.P.O. Box 547 Ft. Recovery, OH 45846 Ph: (419) 375-2376 Fax: (419) 375-2708 www.

-9-NOTE: This is a general list of parts for a leaner with tarp, so some of these will be already installed on arrival or installed in sideboard set

Use the Hanger Bracket to mark and drill four 3/8” holes on the rear of the cart as shown above. The 29 3/4” dimension is from the top of the shell,

STEP - T3.0STEP - 1.0STEP - T4.0-11-Use a pair of vise grips or extra set of hands to temporarily hold the 2 pieces of drip edge (Detail #4) to the ne

STEP - T5.0STEP - 1.0STEP - T5.1-12-SpliceThere should be a splice plate already installed on the end cap that is on the 1500 Grain Cart. Place the 4

STEP - T6.0STEP - 1.0STEP - T7.0-13-STANDARD GRAIN CART TARP INSTALLATIONRuntheridgecablesthroughthe3augersideslotsinthefrontendcapsot

Slide all *bows under the pre-tensioned ridge cables. Then install two 1/4”-20 x 3/4” serrated ange hex bolts and two 1/4”-20 serrated ange hex nut

STEP - T10.0STEP - 1.0STEP - T11.0Insert the 1”x1” 14ga x 192” long square tube into the sleeve on the Canvas Tarp that is on the op-posite side of th

Center the 1” square tube that is riveted to the canvas tarp on the auger side of the cart. Use a 3/8” drill bit to drill three holes through the squ

STEP - T14.0-17-STANDARD GRAIN CART TARP INSTALLATIONInstall the universal joint using two 3/8”-16 x 2” hex bolts and two 3/8”-16 centerlock hex nuts.

LEANER SETUP MANUALSTEP - 1.0NOTEFOR CARTS WITH THE TARP OPTION:The boxed in area shown above is to show which bolt holes should have rounded head b

LEANER SETUP MANUALRemove the bolt that holds the two off auger sideboards together for transport.STEP - 1.0STEP - 1.0STEP - 2.0Install the front

Install the back piece to the rear corner using 3/8” X 1” bolts and nuts.STEP - 3.0STEP - 1.0STEP - 3.1Install the side piece to the rear corner using

Fold out the front sideboard.STEP - 4.0STEP - 1.0STEP - 5.0Insert 3/8” X 1” bolt and nut in adjustment brace and shell bracing. Adjust brace until th

LEANER SETUP MANUALSTEP - 6.0-5-STEP - 5.1-5-STEP - 6.0Install the Front Off Auger Side Brace and bolt with 3/8” X 1”.Fold out the rear sideboard.

LEANER SETUP MANUALSTEP - 7.0-6-Also note that there are now two styles of triangular bolt on bracing. Above is a new brace that has been added.

LEANER MODEL GRAIN CART TARP INSTALLATIONGrain Cart Tarp Installation: Generally speaking, tarp installations are similar for all models of J&M G

-8-7-127LEANER MODEL GRAIN CART TARP INSTALLATION